Clarion BD159RG Installation Manual download pdf (Page 2)

SWI-RC

Step 1 - Wiring

Step A.

Connect the BLACK wire to ground (-).

Verication: Wire or location registers a constant

(-) when probed.

Step B.

Connect the RED wire to switched +12V.

Verication: Wire registers +12V when the

ignition key is turned to the ACC or ON positions.

Step C.

Connect the appropriate interface control input wire (WHITE, YELLOW, ORANGE or

GREEN) to vehicle. please refer to the included chart or visit:

www.pac-audio.com/swixprogramming/swixprogramming.asp

Step D.

If indicated, cut the necessary loop and add the proper resistor as indicated in the

connection chart or on the website.

NOTES

1. The Radio Select Switch MUST be set to the proper position

before programming. Please refer to the chart on page 4 for the

proper setting for your radio.

2. Using T-Taps is NOT recommended. It is VERY important that

ALL connections be solid & secure. Soldering or crimp connects

are best and will provide reliable operation.

Note: Only 3 wires from the SWI-RC will be used during installation. GM vehicles programmed for version #4, will

use 4 wires.

1 2 3 4 5 6 7 8

No comments

Clarion BD159RG Installation Manual Page 2