Clarion M301RC-RET Owner's Manual download pdf (Page 8)

8 M301RC-RET

1. Determine the mounting location is a flat surface with

sufficient rear clearance (2.5”) and access. Ensure

that the installation can be successfully completed

before continuing! If the cable is not long enough, a

24’ extension is available - P/N M101RXC-RET.

2. The remote control panel requires a 2” (51mm) diameter

round hole. Cut the hole and insert the remote control

panel as shown.

VOLUME

SELECT

BAND

SOURCE

POWER

MUTE

3. The mounting bracket is scored with “break lines’ to allow

use with panels of different thicknesses. Determine if the

bracket needs to be shortened, and remove the appropri-

ate number of breakaway segments using a pair of pliers.

Each segment is 1/4” long.

Break Lines

4. Insert the remote control panel into the opening. Make

sure that the gasket behind the remote control panel face

seats completely against the mounting surface.

2” (51mm)

Diameter

Hole

Mounting Bracket

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Clarion M301RC-RET Owner's Manual Page 8