Clarion PSWFRGR User Manual download pdf

Preassembled

(1) Roto-molded subwoofer enclosure

(1) 8"; 2 ohm subwoofer

(1) 100W class "D" amplifier

(1) Speaker grille

Loose Components

(1) 17’ wire harness w/ pigtail style connector

(2) Attachment brackets

(4) 3/4" pilot point wafer Phillips head screws

(4) 1" self taping wafer Phillips head screws

(1) 1/2" ground screw

(1) Star washer

PREPARATION

Parts list

(Qty) Component

Note: Installer MUST disconnect speaker-input leads to amplifier when using line-level input

WIRING:

OVERVIEW

The Clarion Camouflage subwoofer system provides for the installation of a low frequency driver in an enclosure which

is powered by a small low current, high power class "D" (Digital) amplifier. The advantage to using this type of amplifier

is in the low current consumption of the amplifier at high power levels. The class "D" amplifier provided with this system

will produce a rated 100W into a 2 ohm load. The woofer supplied with this system uses a voice coil with rated imped-

ance of 2 ohms, and therefore is not considered a standard woofer. Replacing the woofer with any driver having an

impedance greater than 2 ohms will yield lower power output from the amplifier, and is not recommended.

PROCEDURE

Proper installation of this product requires proper tools and knowledge of car audio principles. If you are not comfortable

performing any of the outlined tasks below, contact a professional installation facility to perform the work.

OUTLINE

• Remove the head unit.

• Connect the Clarion "T" harness between the radio and factory wiring and route the harness extension to transmis-

sion hump of the vehicle.

• Install subwoofer enclosure.

• Test subwoofer enclosure and head unit functions (fade, balance, dim, etc.).

• Adjust subwoofer gain.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CON-

DITIONS.

(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND

(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDE-

SIRED OPERATION.

1 2 3 4

Summary of Contents

Page 1 - PROCEDURE

1Preassembled(1) Roto-molded subwoofer enclosure(1) 8"; 2 ohm subwoofer(1) 100W class "D" amplifier(1) Speaker grilleLoose Components (

Page 2

2Ia. WIRING USING A CLARION “T” HARNESS• STEP 1: Remove the Radio.• STEP 2: Connect the "T" Harness.A. Unplug factory wires from radio.B.

Page 3 - IV. TEST THE ENCLOSURE

3II. RUN WIRE HARNESSA. Route wire harness behind the drivers seat.B. Plug in Clarion”T” harness or hard wire pigtail harness in thedash.III. INSTALL

Page 4 - VI. REASSEMBLE THE VEHICLE

4V. ATTACH THE ENCLOSURE TO VEHICLEA. Press enclosure firmly against the rear wall.B. Screw in brackets to the vehicle floor using the (4) supplied 1&

Comments to this Manuals

No comments

Clarion PSWFRGR User Manual

Browse online or download User Manual for Fans Clarion PSWFRGR. Clarion PSWFRGR User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Fans Clarion PSWFRGR