Clarion PSWFF150 User Manual download pdf

PREPARATION

Note: Installer MUST disconnect speaker-input leads to amplifier when using line-level input

WIRING:

OVERVIEW

The Clarion Camouflage subwoofer system provides for the installation of a low frequency driver in an enclosure which

is powered by a small low current, high power class "D" (Digital) amplifier. The advantage to using this type of amplifier

is in the low current consumption of the amplifier at high power levels. The class "D" amplifier provided with this system

will produce a rated 100W into a 2 ohm load. The woofer supplied with this system uses a voice coil with rated imped-

ance of 2 ohms, and therefore is not considered a standard woofer. Replacing the woofer with any driver having an

impedance greater than 2 ohms will yield lower power output from the amplifier, and is not recommended.

PROCEDURE

Proper installation of this product requires proper tools and knowledge of car audio principles. If you are not comfortable

performing any of the outlined tasks below, contact a professional installation facility to perform the work.

OUTLINE

• Remove the head unit.

• Connect the Clarion "T" harness between the radio and factory wiring and route the harness extension to rear pas-

senger side of the vehicle.

• Remove rear quarter trim panel.

• Install subwoofer enclosure.

• Test subwoofer enclosure and head unit functions (fade, balance, dim, etc.).

• Adjust subwoofer gain.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CON-

DITIONS.

(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND

(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDE-

SIRED OPERATION.

Preassembled

(1) roto-molded subwoofer enclosure

(1) 8"; 2 ohm subwoofer

(1) 100W class "D" amplifier

(1) grille

Loose Components

(1) 3’ wire harness w/ pigtail style connector

(1) carpet for tray

(2) mounting brackets

(4) 3/4" pilot point screws

(2) 1" self taping screws

(1) 1/2" self taping screw

(1) star washer

(2) leveling feet

(4) hex-nuts

Parts list

(Qty) Component

1 2 3 4

Summary of Contents

Page 1 - PROCEDURE

1PREPARATIONNote: Installer MUST disconnect speaker-input leads to amplifier when using line-level inputWIRING:OVERVIEWThe Clarion Camouflage subwoofe

Page 2

2Ia. WIRING USING A CLARION “T” HARNESS• STEP 1: Remove the Radio.• STEP 2: Connect the "T" Harness.A. Unplug factory wires from radio.B.

Page 3 - IV. TEST SUBWOOFER ENCLOSURE

3II. REMOVE FLOOR VENT TRIM COVERA Remove the (3) panel hold down trees located on each side ofthe black floor vent cover.III. INSTALL WIRE HARNESSA.

Page 4 - IX. REASSEMBLE THE VEHICLE

4VI. INSTALL THE SUPPLIED L SHAPED BRACKETS TO THE ENCLOSUREA. Position “L” bracket on enclosure. B. Bracket will be screwed in using two 3/4" pi

Comments to this Manuals

No comments

Clarion PSWFF150 User Manual

Browse online or download User Manual for Microphones Clarion PSWFF150. Clarion PSWFF150 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Microphones Clarion PSWFF150