NOTE: This product is intended for installation by a professional installer only!Any attempt to install this product by any person other than a traine
11system features menusfeature descriptions1 ACTIVE/PASSIVE ARMING: When active arming is selected, the starter kill will arm (if connected)only when
128 DOUBLE PULSE UNLOCK OFF/ON: Some vehicles require two pulses on a single wire to unlock thedoors. When the double pulse unlock feature is turned o
13Channels #4-6: Channels 4 through 6 are used to assign the arm, disarm and panic functions to sep-arate buttons on the remote control. Teaching a bu
14remote configurationsThe transmitters can be programmed with the standard or single button arm/disarm configurations byusing the Auto Learn function
15power-upPower-up ensures that the when the system is powered up it will return to the same state it was in whenpower is disconnected. For a full des
163-Pin 2-Wire DoorLock HarnessOverrideSwitchPro SecurityProgrammer®™wiring quick reference guide
Get StartedGet ProtectedUngo Pro Security661 W. Redondo Beach Blvd.Gardena, Ca. 90247800-GO-CLARION© 2003 Directed Electronics, Inc. - All rights rese
3table of contentsprimary harness (H1) wire connection guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4primary har
4primary harness (H1) wire connection guideprimary harness (H1) wiring diagramThe primary harness supplied with this unit is the standard 12-pin harne
5H1/2 WHITE (-) Parking Light OutputThis wire provides a (-) 200mA output to flash the parking lights. This is suitable for driving (-) lightcontrol w
6H1/6 BLUE (-) 200 mA Second Unlock OutputThe H1/6 BLUE output is used for progressive unlock. A progressive unlock system unlocks the driver'sdo
7H1/11 RED (+)12V constant power inputBefore connecting this wire, remove the supplied fuse. Connect to the positive battery terminal or theconstant 1
8door lock harness (H4), wire connection guide_________peripheral plug-in harnessesLED, 2-pin WHITE plugThe LED operates at (+) 2 volt DC and plugs in
9Pro Security Programmer interface, 3-pin portThe BLACK three-pin port is provided for programming of the unit. When using the ProSecurity Programmer,
103. Transmit. The transmitter is used to select the desired setting. As shipped, the unitis configured to the LED ON settings. These are the default
Comments to this Manuals