Clarion CZ102 Owner's Manual download pdf (Page 6)

Handling Discs

Handling

• New discs may have some roughness

around the edges.

If such discs are used,

the player may not work or the sound may

skip. Use a

ball-point pen or the like to

remove any roughness from the edge of

the disc.

• Never stick labels

on

the surface of the disc

or mark the surface with a pencil or pen.

• Never play a disc with any cellophane tape

or other glue

on

it

or with peeling off marks.

If you try to play such a disc, you may not

be able to get

it

back out of the player or

it

may damage the player.

• Do not

use discs that have large scratches,

are misshapen, cracked, etc.

Use of such discs may cause misoperation

or damage.

• To remove a disc from

its storage case,

press down

on

the center of the case and

lift the disc out, holding

it

carefully by the

edges.

• Do not use commercially available disc

protection sheets or discs

equipped with

stabilizers, etc. These may damage the

disc or cause breakdown of the internal

mechanism.

5

CZ102

Storage

• Do not expose discs to direct sunlight or

any heat source.

• Do not expose discs to excess humidity or

dust.

•

Do

not expose discs to direct heat from

heaters.

Cleaning

• To remove fingermarks and dust, use a soft

cloth and wipe

in

a straight line from the

center of the disc to the circumference.

Do not use any solvents, such as

commercially available cleaners, anti-static

spray, or thinner to clean discs.

• After using special disc cleaner, let the disc

dry off

well before playing

it.

On Discs

• Never turn off the power and remove the

unit from the car with a disc loaded.

A CAUTION

For your safety, the driver should not Insert

or eject a disc while driving.

Basic Operations

Note:

• Refer to the diagrams

in

"3.

CONTROLS"

when reading this chapter.

A CAUTION

When the unit

Is

turned on, starting and

stopping the engine with

Its volume

raised to the maximum level may harm

your hearing.

Be

careful about adjusting the volume.

Power on I

off

Notes:

• Start the engine before using this unit.

• Be careful about using this unit for a long

time without running the engine.

If you

drain the car's battery too far, you may not

be able to start the engine and this can

reduce the service life of the battery.

1.

Start the engine. The power button I knob

illumination

on

the unit will light up.

~

EngineON

~position

2.

Press the [SRC I

<!.>

] button

on

the front

panel or the remote control to turn

on

the

power under standby mode. The unit goes

back to the last status after power

on.

3.

Press and hold the [SRC I

<!.>

] button

on

the front panel or the remote control to

turn off the power.

Mute

Press the [MUTE] button

on

the remote

control to mute the volume from the unit.

Note.

Doing the operation above again or adjusting

volume will release muting.

Volume adjustment

Turn the [VOLUME] knob

on

the front panel

or press the [

.A.

] or [ ""' ] button

on

the

remote

control.

The adjustable range of volume

is

0 to

40.

A CAUTION

While driving, keep the volume level at

which

external sounds can still be heard.

Playing source selection

Press [SRC I

<!.>

] button

on

the front panel or

remote control repeatedly to choose desired

playing source.

Notes:

Playing source selection means selecting

which mode, such as

DISC mode, RADIO

mode and

AUX

mode.

Display system time

Press the [DISP] button

on

the front panel or

[DISP] button

on

the remote control to switch

the display information, system time and

playing source.

RESET

Note:

*When

the [RESET] button

is

pressed,

preset radio stations, titles, etc. stored

in

memory are cleared.

RESET

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments