27
English
DXZ468RMP
• Anti-theft indicator
The red Anti-theft indicator is a function for pre-
venting theft. When the DCP is removed from the
unit, this indicator blinks.
∗ The factory default setting is “OFF”.
2-1. Select “ BLINK LED”.
3-1. Turn the
[
ROTARY
]
knob to select “ON” or
“OFF”.
• Setting the external amplifier
∗ The factory default setting is “OFF”.
2-1. Select “ AMP CANCEL”.
3-1. Turn the
[
ROTARY
]
knob to select “ON” or
“OFF”.
• ON:
Use with connected AMP.
Operations Common to Each Mode
• Selecting AUX/TEL
You can listen to sounds and music from external
devices or your telephone calls from the speak-
ers when connected to this unit.
When TEL INT or External device is connected
to this unit, you can select TEL mode or AUX
mode.
∗ The factory default setting is “AUX”.
2-1. Select “ AUX/TEL”.
3-1. Turn the
[
ROTARY
]
knob to select “AUX” or
“TEL”.
• Dimmer control
You can setting the dimmer control “ON” or “OFF”.
∗ The factory default setting is “ON”.
2-1. Select “ DIMMER”.
3-1. Turn the
[
ROTARY
]
knob to select “ON” or
“OFF”.
To change other settings
1. Press the
[
ADJ
]
button to switch to the
adjustment selection display.
2. Press the
[ , ]
lever upward or downward
to select the “item name”.
Each time the
[ , ]
lever is pressed up/
down, the item display changes in the following
order:
“
BLINK LED” “AMP CANCEL”
(
“LINK ACT”
)
“LANGUAGE” “AUX/
TEL” “AUX SENS” “TEL-SPEAKER”
“TEL-SWITCH”
“SYSTEM CHECK ”
∗ Item in brackets only available if it's connected.
3. Turn the
[
ROTARY
]
knob to select the “desired
setting item”.
∗ After completing settings, press the
[
ADJ
]
but-
ton to return to the previous mode.
• Adjusting the display contrast
You can adjust the display contrast to match the
angle of installation of the unit.
∗ The factory default setting is “08”.
(
Adjustment level: 01 to 16
)
2-1. Select “ CONTRAST”.
3-1. Turn the
[
ROTARY
]
knob to adjust the
contrast.
• AUX :
AUX/TEL input cable is for external Audio input.
• TEL :
AUX/TEL input cable is for cellular phone audio
input.
• Selecting AUX IN sensitivity
Make the following settings to select the sensi-
tivity when sounds from external devices con-
nected to this unit are difficult to hear even after
adjusting the volume.
∗ The factory default setting is “MID”.
2-1. Select “ AUX SENS”.
3-1. Turn the
[
ROTARY
]
knob to select “LOW”,
“MID” or “HIGH”.
Push ENT
• OFF:
Use with inside AMP.
Comments to this Manuals