Clarion ProSecurity RK20 Installation Guide download pdf (Page 32)

shock sensor harness, 4-pin connector

Inputs shorter than 0.8 seconds will trigger the Warn Away® response, while inputs longer than 0.8 seconds will

trigger full alarm sequence and report Zone Two. If installing an optional Directed Electronics dual stage sensor,

connect to the green wire as shown below. The diagram below eliminates the need for diodes to isolate the sensors.

Diagram for adding optional Directed Electronics dual stage sensor to green wire (Zone 2):

Inputs shorter than 0.8 seconds will trigger the Warn Away® response, while inputs longer than 0.8 seconds will

trigger full alarm sequence and will also report Zone Two.

Do not use these for anything besides the plug-in shock sensor.

tach learning

To learn the tach signal:

1. Start the vehicle with the key.

2. Within 5 seconds, press and HOLD the Valet/Program switch.

DRW-96

RED and BLACK: RED is (+)12V constant, BLACK is (-) ground

BLUE (-) multiplex input, zone 2

GREEN (-) multiplex input, zone 2

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 59 60

No comments

Clarion ProSecurity RK20 Installation Guide Page 32