Clarion APX200.2 User Manual

4. A secure clean ground connection is critical to the performance of yourClarion amplifier. Use the shortest ground wire possible snd securely conne

11Figure 6. - Electrical connections for the APX200.2 or the APX400.2

SETTING THE GAINAfter completing the installation, follow these steps to set the Gain Control andthen perform the Final System Checks.1. Turn the Gain

FINAL SYSTEM CHECKS1. Start the engine and turn on the source unit. After a two-second delay,slowly increase the Volume Control and listen to the aud

14ProblemDistorted audio.SolutionGain is not set properly, or damaged speaker cones. Review Setting Gain;inspect each speaker cone for signs of damag

NOTES15

661 W. Redondo Beach Blvd.Gardena, CA 902471-800-GO-CLARIONwww.clarion-usa.comAPX2CH-10 Rev.1 (02/00)

INTRODUCTIONThe Clarion APX200.2 and APX400.2 are full-featured two-channel amplifiers.incorporating the following features:• Full frequency response

DESCRIPTIONThe Clarion APX200.2 and APX400.2 two-channel amplifiers provide 2x70watts and 2x110 watts of power into a 4 ohm load and 2x110 watts and 2

• Gain Control - This allows you to set the nominal operating level of theamplifier. The amplifier’s range, 250mV to 2.5V for RCA inputs or 500mV to5V

CONNECTIONS FOR POWER AND SPEAKERSThe rear panel of the APX200.2 and APX400.2 both contain power and speakerconnections as shown below.51. Left Speake

APPLICATIONSThe Clarion APX200.2 and APX400.2 2-channel car audio amplifiers can beused in a variety of system applications. Here are some examples to

2-Channel Full-Range, Satellite, or Subwoofer Stereo System(Set INPUT SELECT Switch to STEREO)7Set X-Over Mode as shown.Set X-Over Mode as shown;adjus

Mixed-Mode Satellite and Subwoofer System(Set INPUT SELECT Switch to STEREO)8Set X-Over Mode to OFF.FREQ (hz)80100125150200L (mH)8.06.45.14.23.2C (uF)

INSTALLATIONThis section lists Mounting and Wiring Precautions for installing a ClarionAPX200.2 or APX400.2. Combined with the experience of a profes