Clarion UNGO MS8300 Installation Guide download pdf (Page 28)

Ungo ProSecurity

The vehicle starts, but the starter keeps running:

1. Is the system programmed for engine checking OFF or voltage sense? When programmed for either or these

features, the engine cranks for the preprogrammed crank time regardless of how long it takes for the vehicle to actually

start. Adjust to a lower cranking time.

2. Was the Tach learn successful? The LED must light solid and bright to indicate a successful learn.

3. Make sure that there is a tach signal at the Purple/White tach input wire on the remote start. If there is not a tach

signal, recheck the connection to the vehicle’s tach wire and make sure the wire is not broken or shorted to ground

leading to the remote start.

The vehicle will start, but will only run for 10 seconds:

1. Is the remote start programmed for voltage sense? Try programming the unit for low voltage reference. If this does

not work, a tach wire should be used.

2. Check diagnostics.

The climate control system does not work during remote start activation:

Either the wrong accessory wire is being energized or more than one ignition or accessory wire must be energized in

order to operate the climate control system.

149

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 38 39

No comments

Clarion UNGO MS8300 Installation Guide Page 28