Clarion VM700B Owner's Manual download pdf (Page 15)

VM700B 15

English

Owner’s Manual

Wiring the Monitor

Precautions

• Disconnect the negative (-) battery terminal before making any wiring connections.

• Be particularly careful where you route cables. Keep the cable away from source of

heat, such as the engine, exhaust system, and etc. Heat can damage cables.

• If the fuse should blow, make sure all connections are correct and no wires are

damaged before replacing the fuse. Always use fuses that are the same amperage

value as the original. When replacing a fuse, never let the battery side touch any metal

part or any other wire.

Procedure

1. Find a place in the vehicle for the video source(s).

2. Connect the 2 mini DINs connectors of 3 meters cable to monitor’s DIN connectors.

3. Run the 3 meter cable thru the inside car seat back to the bottom. Remain about 30

centimeters inside the car seat.

4. Create passage holes for the power and video cables.

When drilling through metal or plastic, use grommets to protect the cables from sharp

edges that could penetrate the insulation and cause a short circuit and device failure.

5. Connect the ground lead (black) securely to a clean metal plate on the vehicle.

Use sand paper to remove any paint from the surface where you attach the ground

terminal.

6. Reconnect the negative (-) battery terminal.

7. This monitor is recommended to be installed by professional installer.

VM700B

AUDIO R1

MINI DIN

AUDIO L1

VIDEO 1

RED

WHITE

YELLOW

ACC

GROUND

+12V

AUDIO R2

AUDIO L2

VIDEO 2

RED

YELLOW

WHITE

FILTER

BOX

OUT

RED

FUSE

BLACK

YELLOW

3 meters

(~10 feet)

VM700B Manual 082509 R2.indd 15 8/28/2009 9:58:38 AM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 49 50

Comments to this Manuals

No comments

Clarion VM700B Owner's Manual Page 15

Comments to this Manuals

Related products and manuals for Car video systems Clarion VM700B