Clarion VRX633R Owner's Manual download pdf (Page 5)

VRX633R 51

English

Installation and Wire

connection manual

1. When the rear of the main unit has been se-

cured with the method shown in Figure 6

unfasten the special screw.

2. Remove the outer escutcheon.

3. Insert the hook plate between the spring and

the universal mounting bracket, fit tab

B

of

the spring into hole

A

of the hook plate, then

pull the main unit out by the hook plate. (In-

sert both the right and left edges of the hook

plate.) (Figure 9)

Note: Keep the hook plate. You cannot remove the

main unit without disengaging the hook plate.

6. REMOVING THE MAIN UNIT

1. Be sure to turn the power off before wiring.

2. Be particularly careful where you route the

wires.

Keep them well away from the engine, and

exhaust pipe, etc. Heat may damage the

wires.

3. If the fuse should blow, check to see if the

wiring is correct.

If it is, replace the fuse with a new one with

the same amperage rating as the original.

4. When any fuse is to be replaced, pull out the

fuse (15A) at the rear of the main unit and

put in a new one (Fig.10).

After the connection, fix the lead by a clamp

or insulation tape for protection.

7. CAUTIONS ON WIRING

CAUTION

Figure 10

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments