Clarion UNGO PRO SECURITY SYSTEM K20 Installation Guide

NOTE: This product is intended for installation by a professional installer only!Any attempt to install this product by any person other than a traine

10System Features MenusNote: Factory default settings are shown in BOLD.Note: For feature number 1-4, the 3.5 second door lock pulse setting the horn

11Transmitter/Receiver Learn RoutineThe system comes with two transmitters that have been taught to the receiver. The receiver can store up to four di

12Transmitter ConfigurationsThe transmitters can be programmed with the standard or single button arm/disarm configurations by using the Auto Learn fu

13Wiring Quick Reference GuideLEDValet SwitchGREEN/BLACK Lock #30 Common OutputWHITE/BLUE (-) 200 mA Channel 3 Valididty OutputBLACK/WHITE Output of D

Get StartedGet ProtectedUngo Pro Security661 W. Redondo Beach Blvd.Gardena, Ca. 90247800-GO-CLARION© 2005 Directed Electronics, Inc. - All rights rese

2

3table of contentsPrimary Harness (H1), 18-pin connector . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

4Primary Harness (H1), 18-pin connector______________________________________________________H1/1 RED (+)12V Constant Power InputBefore connecting thi

5H1/5 GREEN/BLACK Lock #30 Common (Output)The system has door lock relays on-board, and can directly interface with most electric power door lock syst

6H1/14 WHITE/BLUE (-) Channel 3 OutputThis wire provides a (-) 200 mA output whenever the transmitter code controlling Channel 3 is received. This out

7H1/18 RED/WHITE Channel 2, 200mA (-) outputWhen the system receives the transmitter code controlling Channel 2 for longer than 1.5 seconds, the red/w

8Valet/Program Switch, 2-Pin BLUE PlugThe Valet/Program button should be accessible from the driver’s seat. It plugs into the BLUE port on the side of

9The learn routine will be exited if:➤The ignition is turned on.➤The Valet/Program switch is pressed too many times.➤More than 15 seconds elapses betw