Clarion CZ102 Owner's Manual download pdf (Page 11)

English

9. INSTALLATION / WIRE

CONNECTION GUIDE

1) Before Starting

1. This set is exclusively for use in cars with

a negative ground 12 V power supply.

2. Read these instructions carefully.

3. Be sure to disconnect the battery

“terminal” before starting. This is to

prevent short circuits during installation.

(Figure 1)

2) Package Contents

3) General Cautions

1. Do not open the case. There are no

user serviceable parts inside. If you

drop anything into the unit during

installation, consult your dealer or an

authorized Clarion service center.

2. Use a soft, dry cloth to clean the case.

Never use a rough cloth, thinner, benzine,

or alcohol etc. For tough dirt, apply a little

cold or warm water to a soft cloth and wipe

off the dirt gently.

CONTENTS

1) Before Starting ................................................................................. 10

2) Package Contents ............................................................................ 10

3) General Cautions ............................................................................. 10

4) Cautions on Installation .................................................................... 10

5) Installing the Source Unit ................................................................. 10

6) Removing the Source Unit ............................................................... 11

7) Wiring and Connections ................................................................... 12

8) Connecting the Accessories ............................................................. 12

Source unit ..................................................1

Front panel ..................................................1

Trim ring ......................................................1

Mounting bracket ......................................... 1

Screws M5x6 mm ........................................ 4

L-key ............................................................ 2

Wire connector ............................................1

Remote control unit (with battery)................1

Owner’s manual...........................................1

Warranty card .............................................. 1

Special screw (Front panel lock) .................1

Car battery

Figure 1

4) Cautions on Installation

1. Prepare all articles necessary for installing

the source unit before starting.

2. Install the unit within 30° of the

horizontal plane. (Figure 2)

3. If you have to do any work on the car

body, such as drilling holes, consult your

car dealer beforehand.

4. Use the enclosed screws for installation.

Using other screws can cause damage.

(Figure 3)

5) Installing the Source Unit

1. Place the mounting bracket into the instrument panel, use a screwdriver to bend each stopper

of the mounting bracket inward, then secure the stopper.

2. Wire as shown in Section 7) .

3. Insert the source unit into the mounting bracket until it locks.

4. Take care of the top and bottom of the trim ring and mount it so that all the hooks are locked.

Notes:

1. Some car models require special mounting kits for proper installation.

Consult your Clarion dealer for details.

2. Fasten the front stopper securely to prevent the source unit from coming loose.

• Console opening dimensions

(182 mm)

7-3/16"

2-1/8"

53 mm

Max 30

Chassis Chassis

Damage

Max. 6 mm (M5 screw)

Figure 2 Figure 3

Hole

1 2 ... 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Clarion CZ102 Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for CD players Clarion CZ102