Clarion VRX868RVD Owner's Manual download pdf (Page 76)

VRX868RVD

English

INSTALLATION AND WIRE

CONNECTION MANUAL

6. REMOVING THE MAIN UNIT

1. When the rear of the main unit has been

secured with the method shown in Figure 6

unfasten the special screw.

2. Remove the outer escutcheon.

3. Insert the hook plate between the spring and

the universal mounting bracket, fit tab B of

the spring into hole A of the hook plate, then

pull the main unit out by the hook plate. (Insert

both the right and left edges of the hook

plate.) (Figure 9)

Note:

• Keep the hook plate. You cannot remove the main

unit without disengaging the hook plate.

7. CAUTIONS ON WIRING

1. Be sure to turn the power off before wiring.

2. Be particularly careful where you route the

wires.

Keep them well away from the engine, and

exhaust pipe, etc. Heat may damage the

wires.

3. If the fuse should blow, check to see if the

wiring is correct.

If a fuse is blown, replace it with a new one of

the same amperage rating as the original

(15A FUSE).

4. To replace the fuse, remove the old fuse of

the power supply lead and insert the new one.

(Figure10)

Note:

• There are various types of fuse holder. Do not let

the battery side touch other metal parts.

CAUTION

caution

After the connection, fix the lead by a clamp

or insulation tape for protection.

Universal mounting bracket

2-Hook plate

Outer escutcheon

Instrument panel

Spring

Main

Unit

Figure 9

Fuse (15A FUSE)

Fuse holder

Figure 10

VRX868RVD.book Page 78 Thursday, April 27, 2006 3:41 AM

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 82

Comments to this Manuals

No comments

Clarion VRX868RVD Owner's Manual Page 76

Comments to this Manuals

Related products and manuals for Car video systems Clarion VRX868RVD