Clarion CZ102 Owner's Manual download pdf (Page 6)

English

Handling Discs

Handling

• New discs may have some roughness

around the edges. If such discs are used,

the player may not work or the sound may

skip. Use a ball-point pen or the like to

remove any roughness from the edge of

the disc.

• Never stick labels on the surface of the disc

or mark the surface with a pencil or pen.

• Never play a disc with any cellophane tape

or other glue on it or with peeling off marks.

If you try to play such a disc, you may not

be able to get it back out of the player or it

may damage the player.

• Do not use discs that have large scratches,

are misshapen, cracked, etc.

Use of such discs may cause misoperation

or damage.

• To remove a disc from its storage case,

press down on the center of the case and

lift the disc out, holding it carefully by the

edges.

• Do not use commercially available disc

protection sheets or discs equipped with

stabilizers, etc. These may damage the

disc or cause breakdown of the internal

mechanism.

Storage

• Do not expose discs to direct sunlight or

any heat source.

• Do not expose discs to excess humidity or

dust.

• Do not expose discs to direct heat from

heaters.

Cleaning

• To remove ngermarks and dust, use a soft

cloth and wipe in a straight line from the

center of the disc to the circumference.

• Do not use any solvents, such as

commercially available cleaners, anti-static

spray, or thinner to clean discs.

• After using special disc cleaner, let the disc

dry off well before playing it.

On Discs

• Never turn off the power and remove the

unit from the car with a disc loaded.

CAUTION

For your safety, the driver should not insert

or eject a disc while driving.

Ball-point pen

Roughness

4. CAUTIONS ON HANDLING

5. OPERATIONS

Basic Operations

Note:

• Refer to the diagrams in “3. CONTROLS”

when reading this chapter.

CAUTION

When the unit is turned on, starting and

stopping the engine with its volume

raised to the maximum level may harm

your hearing.

Be careful about adjusting the volume.

Power on / off

Notes:

• Start the engine before using this unit.

• Be careful about using this unit for a long

time without running the engine. If you

drain the car’s battery too far, you may not

be able to start the engine and this can

reduce the service life of the battery.

1. Start the engine. The power button / knob

illumination on the unit will light up.

Engine ON

position

2. Press the [SRC /

] button on the front

panel or the remote control to turn on the

power under standby mode. The unit goes

back to the last status after power on.

3. Press and hold the [SRC / ] button on

the front panel or the remote control to

turn off the power.

Mute

Press the [MUTE] button on the remote

control to mute the volume from the unit.

Note:

Doing the operation above again or adjusting

volume will release muting.

Volume adjustment

Turn the [VOLUME] knob on the front panel

or press the [ ] or [ ] button on the

remote control.

The adjustable range of volume is 0 to 40.

CAUTION

While driving, keep the volume level at

which external sounds can still be heard.

Playing source selection

Press [SRC / ] button on the front panel or

remote control repeatedly to choose desired

playing source.

Notes:

Playing source selection means selecting

which mode, such as DISC mode, RADIO

mode and AUX mode.

Display system time

Press the [DISP] button on the front panel or

[DISP] button on the remote control to switch

the display information, system time and

playing source.

RESET

Note:

* When the [RESET] button is pressed,

preset radio stations, titles, etc. stored in

memory are cleared.

RESET

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Clarion CZ102 Owner's Manual Page 6

Comments to this Manuals

Related products and manuals for CD players Clarion CZ102